|
Post by oregonbob on Nov 28, 2015 18:51:38 GMT
I'm looking for information on sharpening the HSS cutters used on the Turnmaster and am not having much luck. I did find something on a cutter sharpening system in literature on the resources tab but the site denies me access to it with a 403 access denied message. Any suggestions? If you can point me to sharpening info for these cutters I would appreciate it.
|
|
|
Post by Robert on Dec 3, 2015 15:30:31 GMT
|
|
|
Post by oregonbob on Dec 4, 2015 14:20:06 GMT
Thank you Robert. This is the information I was looking for.
|
|
|
Post by Jeff Farris on Dec 5, 2015 12:11:52 GMT
Bob,
Beyond the link that Robert provided, the cutters can usually be sharpened just by honing the top face on a diamond hone. If the edge is damaged, then you would need to re-grind the bevel, which is much easier using the optional tip holder available from nearly all Robert Sorby dealers.
|
|