|
|
Post by saltfleetturner on May 12, 2017 18:40:21 GMT
I recently tried to set up for a 35deg fingernail profile, only to find that the gouge would not go far enough in before running out of flute. Brand new 3/8 spindle gouge! Can someone explain how to achieve this and also what happens when the gouge wears down with use and again runs out of flute?
|
|
|
|
Post by woodster on May 28, 2017 9:39:18 GMT
Have you got the profile jig set to the default angle of 120°? If you have and you still can't get the grinding angle on the gouge then you may need to alter the angle of the jig but make a note of it and don't forget to reset to 120° for the rest of your tools. Edit: found this, see page 25. www.axminster.co.uk/media/downloads/210952_manual.pdf |
|
