|
Post by jimh001 on Jan 22, 2021 7:33:30 GMT
Is the template for resetting the fingernail jig to factory setting still available. The link to page goes to not found. One of the guys who I lent mine to has set it away from the factory set where I had ground my tools.
|
|
|
Post by Pete on Jan 22, 2021 15:59:06 GMT
Hi Jim Just checked mine and my suspicion was right! 120°, if my answer isn't sufficient, can you post the link to the missing page, I can ask Clive but know he is extra busy at the moment so would prefer to give him all the info on one contact.
|
|
|
Post by jimh001 on Jan 22, 2021 21:19:18 GMT
Thanks, that gets me halfway. Can you also check the distance from the knuckle centre axis to the collar.
|
|
|
Post by jimh001 on Jan 22, 2021 21:40:45 GMT
The link I tried to use to get template is in a reply to post below by apache We provide a template if you need to reset the arm to factory settings. You can see this at the foot of page one of the instructions for the Universal Sharpening System www.robert-sorby.co.uk/pdf/sharpening_system_instruction.pdfPrint it out to get a full size template if resetting is necessary. This now goes to a page not found. I think it is an older version of the instruction manual.
|
|
|
Post by Pete on Jan 22, 2021 21:51:08 GMT
62mm knuckle centre axis to the collar. New link for product documentation is Sorby manuals but not found the jig you were talking about.
|
|
|
Post by jimh001 on Jan 24, 2021 3:28:09 GMT
Thanks all sorted
Reset details
Angle 120 degrees Distance from knuckle centre to collar 62 mm.
|
|